9/10/2023 0 Comments Using freecad in draft mode![]() ![]() To create a Draft Line use the make_line method ( introduced in version 0.19) of the Draft module. See also: Autogenerated API documentation and FreeCAD Scripting Basics. → Draft → General settings → Draft tools options → Use Part Primitives when available option is checked, the command will create a Part Line instead of a Draft Line. Note that you must move the pointer in the 3D view for the change to take effect. → Draft → General settings → Draft tools options → Set focus on Length instead of X coordinate. To change the initial focus of the task panel to the Length input box: Edit → Preferences.→ General → Units → Units settings → Number of decimals. To change the number of decimals used for the input of coordinates, lengths and angles: Edit → Preferences.See also: Preferences Editor and Draft Preferences. Draft Lines and Draft Wires can be joined with the Draft Wire command, the Draft Join command or the Draft Upgrade command.A Draft Line can be edited with the Draft Edit command.Press Esc or the Close button to abort the command.Press S to switch Draft snapping on or off.If continue mode is on, the command will restart after finishing, allowing you to continue creating lines. Press T or click the Continue checkbox to toggle continue mode.If global mode is on, coordinates are relative to the global coordinate system, else they are relative to the working plane coordinate system. Press G or click the Global checkbox to toggle global mode.If relative mode is on, the coordinates of the second point are relative to the first point, else they are relative to the coordinate system origin. Press R or click the Relative checkbox to toggle relative mode.Depending on the input box that receives the focus the Angle checkbox is checked or unchecked. Press H to change the focus from the X input box to the Length input box and back.Check the Angle checkbox to constrain the pointer to the specified angle.To use polar coordinates enter a value for the Length and a value for the Angle, and press Enter after each.It is advisable to move the pointer out of the 3D view before entering coordinates. Or you can press the Enter point button when you have the desired values. To manually enter coordinates enter the X, Y and Z component, and press Enter after each.The shortcuts mentioned here are the default shortcuts. The single character keyboard shortcuts available in the task panel can be changed. Pick the second point in the 3D view, or type coordinates and press the Enter point button.Pick the first point in the 3D view, or type coordinates and press the Enter point button.Select the Drafting → Line option from the menu.There are several ways to invoke the command:.See also: Draft Tray, Draft Snap and Draft Constrain. The Draft Line command creates a straight line.Ī Draft Line is in fact a Draft Wire with only two points. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |